Prove it on your own parts before you scale up.
Made in South Korea. Stocked and supported in Los Angeles.
Best for sample testing, r&d, and short low-risk runs.
Before you commit to a production unit, prove the process on your own parts. The RW-6 is a four-barrel benchtop machine that runs the same high-energy finish as the big units, at a size that fits on a bench. Shops use it to dial in a recipe, qualify a part, or handle short precision runs without tying up the floor.
Built to run for years, not months.
The same gear-driven turret build goes into every Richwood machine.
Gear-driven turret
The critical, high-stress components are gear-driven, not chain or belt. Fewer wear parts, no slipping in greasy or humid shops, no chain slap, and steady power to every barrel.
Precision bearings
High-grade bearings carry the load at full G-force, run after run, so the machine holds its finish quality over a long service life.
Built to last
Quality components and tight fit and finish throughout. These machines are made to run hard and keep running.
RW-6 at a glance.
Need the full spec sheet? Ask Kevin →
- Country of manufacture
- South Korea
- Barrels
- 4 portable, 1 liter each
- Total capacity
- 4 liters (0.14 cu ft)
- Barrel inside dimension
- 3.93 x 4.92 in
- Machine dimensions
- 27.55 x 22.04 x 20.47 in
- Table stand
- 39.37 x 23.62 x 39.37 in
- Power
- 110V single phase, 14 amps
- Main drive motor
- 1 HP
- Compressed air
- Not required
- Noise level
- 60 dB
- Standards
- NFPA-70 and NFPA-79
- Turret speed
- 0 to 400 RPM
- Barrel speed
- 0 to 800 RPM, 1:2 turret to barrel ratio
3 RW-6 units are on the floor right now.
Watch yours run on video before it ships.