Maximum parts per shift. Four barrels, ready now.
Made in South Korea. Stocked and supported in Los Angeles.
Best for high-volume shops running the most parts per shift.
When you need maximum parts per shift, the RW-220 is the top of the line. Four barrels, a flip-up domed cover, and a separate control panel built to run back to back, all day. This is the machine that takes a full shift of hand deburring off your labor line.
Plug and Play separator
Add for $9,950
The optional Plug and Play separator fits into the opening on the lower-left side of your RW-220, as shown in the installation photo.
Includes three screen sizes for Small, Medium, and Large media. Priced separately from the machine.
Configure Your RW-220 →
High-load transfer gears. Easy-access greasing.
Nylon molybdenum transfer gears
The black transfer gears are made of nylon molybdenum, designed to handle high loads and to shear in the event of a catastrophic failure.
Easy-access grease port system
The grease port system provides convenient access for routine greasing maintenance. The ports and connected orange grease lines are visible at the upper left of the photo.
Protective turret sealer coating
The turret assembly has a sealer coating to help protect it from debris and corrosion.
Built to run for years, not months.
The same gear-driven turret build goes into every Richwood machine.
Gear-driven turret
The critical, high-stress components are gear-driven, not chain or belt. Fewer wear parts, no slipping in greasy or humid shops, no chain slap, and steady power to every barrel.
Precision bearings
High-grade bearings carry the load at full G-force, run after run, so the machine holds its finish quality over a long service life.
Built to last
Quality components and tight fit and finish throughout. These machines are made to run hard and keep running.
RW-220 at a glance.
Need the full spec sheet? Ask Kevin →
- Country of manufacture
- South Korea
- Lid sealing
- Replaceable, adjustable eccentric collars control lid-to-barrel sealing pressure.
- Barrels
- 4 fixed, 55 liters each
- Total capacity
- 220 liters (7.76 cu ft)
- Barrel inside dimension
- 11.61 x 27.44 in
- Compartment dividers
- Yes
- Media separation
- Optional Plug and Play separator: additional $9,950. Includes three screen sizes for Small, Medium, and Large media.
- Machine dimensions (Length x Width x Height)
- 108.26 x 59.44 x 121.25 in
- Power
- 460V three phase, 69 amps
- Main drive motor
- 20 HP
- Turret speed
- 150 RPM, fully adjustable
- Barrel speed
- 150 RPM
- Barrel forward and reverse
- Yes
- Compressed air
- Required
- Noise level
- 70 dB
- Cover
- Flip-up domed
- Controls
- Separate control panel
- Standards
- NFPA-70 and NFPA-79
2 RW-220 units are on the floor right now.
Watch yours run on video before it ships.